Details anzeigen
Einbauzeit etwa: 0,15 Stunde(n)
Gewicht: 0,50 KG
Packungsgrösse (LxHxB): 15x8x3 cm
Anzahl pro Fahrzeug: Anzahl nicht angegeben
Set includes
- Drill with handle
- Awl with handdle
- 5 rubber cords, each 10 cm long
- Tube of glue (12g)
How to use the kit:
1. Locate the area where the tyre has been punctured.
2. Grease the cutter with the glue provided and drive it into the hole, following the angle of the hole fill it well with glue.
3. Thread the cord onto the awl and bend it in half with the ends up.
4. Apply glue to the cord and use the awl to press it into the hole, following the angle of the previous penetration. With a firm motion, push the awl and cord through the damaged area.
Make sure that the cord goes all the way through the tyre.
Be careful not to pull the entire cord inwards.
The two ends of the cord should protrude approximately 0.5 - 1cm above the tyre tread. Firmly remove the stalk from the tyre (do not twist the stalk inside the tyre when removing it - this may break it).
5. Cut off the two protruding ends of the cord leaving 5mm above the tyre. The cord will flush with the tread surface as you drive.
Haben Sie Fragen? Dann schreiben Sie uns eine E-Mail oder rufen Sie uns an.